記事 & ブログ

NASAはLED照明を使用して、宇宙食のおいしさを高める方法を見つけ出しました。

新型コロナウイルス患者に使える大量市場向け人工呼吸器を迅速に市場投入するため、ミネソタ大学とDigiKeyが共同で取り組んだ内容の紹介です。

TDK-Lambda製PFH500電源モジュールは過酷な環境向けの産業用設計基準を満たしています。

IO-Linkを理解して適用し、効率的かつコスト効率よくデプロイして、IIoTの用途でインテリジェントなセンサやアクチュエータと通信します。

ドローンにセンサを追加する際には、電力消費、機能、コストのバランスを慎重に考える必要がありますが、最適な選択肢がいくつかあります。

電源PoLでのMPPT、リモートセンサ監視、GaN（窒化ガリウム）トランジスタは、設計者がAIに基づく電源システムの万一に備えたバックアップとして使用できるオプションに含まれる要素です。

Almost three decades ago, the "brick" DC/DC converter power module was developed, which eventually led to the distributed power architecture (DPA) becoming the de facto standard for point of load (POL) designs.

Home energy systems based on renewable sources, such as solar and wind power, are becoming more popular among consumers and will gain increasing support from governmental bodies.

Flow sensors are used to measure flow velocity, volumetric flow rate, or mass flow of a liquid or gas. Mass flow for gases is specified in units of standard liters per minute (slm) or standard cubic centimeters per minute (sccm).

What once was a straightforward act of transforming an AC waveform into a DC source to power downstream devices is now greatly affected and driven by the power grid to maximize its available power.

Powerline filters protect expensive circuitry from potentially damaging power surges, as well as protecting the AC line from excessive noise conducted back into it from a noisy power converter.

Modular, high-density POL (point-of-load) power DC/DC converters have some excellent advantages over other power management architectures.

DC/DC converters are a great high-frequency noise source. Designers must take careful steps to minimize and contain this noise near and around the converter to keep it from affecting other system components or the AC mains.

Battery size constraints in energy harvesting systems necessitate creativity and innovation in order to maximize efficiency of the power source.

Ambient light sensor (ALS) products are quickly becoming one of the most effective solutions for power management and display quality enhancement in electronic products and systems.

As newer applications and systems tend to have multiple voltages to power DSPs, µCs, FPGAs, and ASICs, modern power supply designs must be able to control how and when these voltages ramp to their final values after the power switch is activated.

Relative humidity (RH) is defined as the ratio of the partial pressure of water vapor (in a gaseous mixture of air and water vapor) to the saturated vapor pressure of water at a given temperature.

Designers using modular power converters for their systems know how critical a thermal derating curve is to the success of their design.

Need a temperature sensor for your next application? You'll first need to sort through the three-letter acronyms before arriving at any BOMs.

A gas detection sensor’s function is to measure the concentration of gases. These devices have different methods to convert the gas detection element’s output to voltage.