エンジニアリングリソース

The STEVAL-ISV003V1 is a demonstration board which implements the microinverter concept and is designed to optimize the power production of each single solar panel by means of DC/AC conversion.

The ability to locate the position of any suitably enabled system anywhere on Earth using the Global Navigation Satellite Systems (GNSS) is useful, but there are a few problems associated with using only GNSS receivers for positioning.

The combination of wide bandwidth, low voltage noise, and low input bias current makes the ADA4625-1 especially suitable for phase-locked loop, active filter amplifiers, high tuning voltage controlled oscillators, and preamplifiers.

The MAX9926U evaluation kit is a fully assembled and tested circuit board that contains a dual-channel differential variable-reluctance (VR or magnetic pickup) sensor interface circuit using a MAX9926U IC in a 16-pin QSOP package.

As the Internet of Things (IoT) stretches into more open spaces, designers are turning to almost ubiquitous cellular networks for secure, reliable, low-power, long-range, wireless machine-to-machine (M2M) communications. However, the choice of cellular network is critical.

The LTC3300 and LTC6804 demonstration circuit is used to simulate the active balancing of 12 Li-Ion cells. This is achieved by using a Capacitor board consisting of 72 supercapacitor locations to simulate 12 Li-Ion cells.

The UMFT234XD is a breakout board that converts USB2.0 Full-Speed to UART. These modules do not have a USB connector, instead, the modules plug directly into the USB host connector.

Switched mode power conversion and industrial controllers use switch mode transistor, semiconductor controlled rectifiers, and related thyristor devices to control power by adjusting the duty cycle of the input waveforms.